LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Escape Base, 3.0 1, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Manual Transaxle/Transmission External Controls) >> Removal And Installation >> Gearshift Lever >> Installation

Gearshift Lever: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position the gearshift lever.
  2. Connect the select cable.
    3. Fig 1: Select Cable
    GF0025433Courtesy of FORD MOTOR CO.
  3. Connect the gearshift cable.
    4. Fig 2: Gearshift Cable
    GF0025434Courtesy of FORD MOTOR CO.
    CAUTION: Make sure the clips are set completely within the cable adapter groove and fully seated.
  4. Install the 2 gearshift cable clips.
    5. Fig 3: Gearshift Cable Clips
    GF0025435Courtesy of FORD MOTOR CO.
  5. Install the 4 gearshift lever bolts.
    • Tighten to 25 Nm (18 lb-ft).
  6. Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION article.
  7. Install the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
scientia non olet · About LEMON Manuals