LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Escape Base, 2.3 Z, FWD, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Cd4E >> Disassembly And Assembly Of Subassemblies >> Main Control Valve Body >> Disassembly

Main Control Valve Body: Disassembly

  1. Remove the manual valve.
    2. Fig 1: Manual Valve
    GF0025019Courtesy of FORD MOTOR CO.
    CAUTION: Do not attempt to remove the solenoid valve body wiring cover.
  2. Remove the 2 solenoid valve body bolts and the solenoid valve body.
    3. Fig 2: Solenoid Valve Body
    GF0025020Courtesy of FORD MOTOR CO.
  3. Remove and discard the solenoid valve body gasket.
    4. Fig 3: Solenoid Valve Body Gasket
    GF0025021Courtesy of FORD MOTOR CO.
  4. Remove the 3 pressure tap plate bolts and the pressure tap plate.
    5. Fig 4: Pressure Tap Plate
    GF0025022Courtesy of FORD MOTOR CO.
  5. Remove and discard the pressure plate tap gasket.
    6. Fig 5: Pressure Plate Tap Gasket
    GF0025023Courtesy of FORD MOTOR CO.
  6. Remove the control valve body to transfer plate bolts, and remove the manual valve detent spring assembly.
    7. Fig 6: Control Valve Body-To-Transfer Plate Bolts
    GF0025024Courtesy of FORD MOTOR CO.
  7. Remove the accumulator body-to-transfer plate bolts.
    8. Fig 7: Accumulator Body-To-Transfer Plate Bolts
    GF0025025Courtesy of FORD MOTOR CO.
  8. Separate the accumulator body from the main control valve body.
    1. Remove the accumulator body assembly.
    2. Remove and discard the accumulator body separator gasket.
    3. Remove the accumulator body separator plate.
    4. Remove and discard the accumulator body separator gasket.
    5. Remove the main control valve body.
    9. Fig 8: Identifying Accumulator Body Assembly
    GF0025026Courtesy of FORD MOTOR CO.
  9. Separate the transfer plate from the main control valve body.
    1. Remove the main control valve body.
    2. Remove and discard the valve body separator plate gasket.
    3. Remove the valve body separator plate.
    4. Remove and discard the valve body separator plate gasket.
    5. Remove the transfer plate.
    10. Fig 9: Identifying Transfer Plate Main Control Valve Body Parts
    GF0025027Courtesy of FORD MOTOR CO.
  10. Remove the intermediate and overdrive accumulator valve plug retaining plate from the accumulator body assembly.
    11. Fig 10: Accumulator Body Assembly
    GF0025028Courtesy of FORD MOTOR CO.
  11. Remove the intermediate and overdrive accumulator valve plug.
    12. Fig 11: Intermediate & Overdrive Accumulator Valve Plug
    GF0025029Courtesy of FORD MOTOR CO.
  12. Remove and discard the intermediate and overdrive accumulator plug seal.
    13. Fig 12: Intermediate & Overdrive Accumulator Plug Seal
    GF0025030Courtesy of FORD MOTOR CO.
    CAUTION: Remove, note location and clean one valve at a time to avoid incorrect installation.
  13. As necessary, disassemble the parts of the accumulator body and main control valve body assemblies.
    • Lubricate and reassemble the parts as soon as possible to avoid accidental damage or incorrect installation.
scientia non olet · About LEMON Manuals