LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Escape Base, 2.3 Z, FWD, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Cd4E >> Disassembly And Assembly Of Subassemblies >> Chain Sprockets >> Assembly

Chain Sprockets: Assembly

  1. Position the No. 16 reverse/overdrive ring gear bearing on the special tools.
    • Position the bearing with the part number facing toward the handle of the special tool.
    2. Fig 1: Positioning No 16 Reverse/Overdrive Ring Gear Bearing On Special Tools
    GF0024942Courtesy of FORD MOTOR CO.
    NOTE: The identification stamping of the bearing goes to the outboard side of the reverse/overdrive ring gear.
  2. Using the special tools, install the No. 16 reverse/overdrive ring gear bearing.
    3. Fig 2: Installing No. 16 Reverse/Overdrive Ring Gear Bearing Using Special Tools
    GF0024943Courtesy of FORD MOTOR CO.
  3. Position the No. 17 stator support bearing on the special tools.
    • Position the bearing with the part number facing toward the handle of the special tool.
    4. Fig 3: Positioning No 17 Stator Support Bearing On Special Tools
    GF0024942Courtesy of FORD MOTOR CO.
    NOTE: The identification stamping of the bearing goes to the outboard side of the reverse/overdrive ring gear.
  4. Using the special tools, install the No. 17 stator support bearing into the stator support sprocket.
    5. Fig 4: Installing No. 17 Stator Support Bearing Into Stator Support Sprocket Using Special Tools
    GF0024944Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals