LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Escape Base, 2.3 Z, FWD, Automatic >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Engine Ignition - 2.3L >> Removal And Installation >> Spark Plugs >> Installation

Spark Plugs: Installation

  1. Inspect the spark plugs.
    Item Part Number Description
    1 - Deposits bridging spark plug gap
    2 - Wet black deposits (oil fouling)
    3 - Dry black deposits (carbon fouling)
    4 - Normal spark plug
    5 - Pre-ignition
    6 - Overheating
    7 - Fused spot deposits
    2. Fig 1: Identifying Spark Plugs Condition
    GF0019760Courtesy of FORD MOTOR CO.
  2. Adjust the spark plug gap as necessary.
    3. Fig 2: Spark Plug Gap (With Specifications)
    GF0024477Courtesy of FORD MOTOR CO.
    CAUTION: Only use hand tools when removing or installing the spark plugs, or damage can occur to the cylinder head or spark plug.
  3. Install the spark plugs.
    • Tighten to 12 Nm (9 lb-ft).
    4. NOTE: Apply a small amount of dielectric grease to the inside of the ignition coil boots before attaching to the spark plugs.
  4. Install the ignition coils and bolts.
    • Tighten to 8 Nm (71 lb-in).
  5. Connect the ignition coil electrical connectors.
  6. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
scientia non olet · About LEMON Manuals