LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Edge SE, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Removal And Installation >> Wheel Speed Sensor - Front >> Removal And Installation

Removal And Installation

  1. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES .
  2. Remove the retainers and position the fender splash shield aside.
  3. Disconnect the wheel speed sensor electrical connector.
  4. Disconnect the 6 push pin fasteners.
  5. Remove the front wheel speed sensor bolt and the wheel speed sensor.
    • To install, tighten to 7 Nm (62 lb-in).
    6. CAUTION: The wheel speed sensor harness must be routed as shown or damage to the harness during vehicle jounce and rebound can occur.
  6. To install, reverse the removal procedure.
    7. Fig 1: Identifying Wheel Speed Sensor Harness
    GF0031572Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals