Cylinder Head: Disassembly

CAUTION: Place cylinder head on a cardboard or wood surface to prevent damage to the joint face.

NOTE: Do not remove the camshaft before removing the roller followers.

Install the special tool between the valve spring coils to prevent valve stem seal damage.

Fig 1: Installing Special Tool Between Valve Spring Coils

Courtesy of FORD MOTOR CO.

CAUTION: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations. Failure to follow these instructions may result in engine damage.

Using the special tool, compress the valve springs and remove the roller followers.

Fig 2: Compressing Valve Spring

Courtesy of FORD MOTOR CO.

Remove the hydraulic lash adjusters.

Fig 3: Locating Hydraulic Lash Adjusters

Courtesy of FORD MOTOR CO.

Using the special tool, compress the valve springs.

Fig 4: Compressing Valve Spring

Courtesy of FORD MOTOR CO.

NOTE: Keep valves and valve spring retainer keys in order so they can be installed in their original positions.

Remove the valve spring retainer keys, the valve spring retainers, the valve springs and the valves.

Fig 5: Valve Spring Retainer Keys, Valve Spring Retainers, Valve Springs & Valves

Courtesy of FORD MOTOR CO.

Remove the valve stem seals.

Fig 6: Valve Stem Seal

Courtesy of FORD MOTOR CO.

NOTE: The camshaft bearing caps must be installed in their original locations. Record camshaft bearing cap locations.

Remove the bolts, the bearing caps and the camshaft.

Fig 7: Bearing Caps & Camshaft

Courtesy of FORD MOTOR CO.