Front Toe Adjustment

Using alignment equipment and the manufacturer's instructions, measure the front toe.
Start the engine and center the steering wheel.
Turn the engine OFF and, using a suitable steering wheel holding device, lock the steering wheel in the straight forward position.
Remove the clamps.

Fig 1: Locating Clamps
Courtesy of FORD MOTOR CO.
Loosen the tie-rod end adjustment nuts.

Fig 2: Locating Tie-Rod End Adjustment Nuts
Courtesy of FORD MOTOR CO.

NOTE: Do not allow the steering gear bellows to twist when the front wheel spindle tie rod is rotated.

Fig 3: Locating Front Wheel Spindle Tie Rods

G04709489

Courtesy of FORD MOTOR CO.

Rotate the front wheel spindle tie rods.
Tighten the nuts to 55 Nm (41 lb-ft).

Fig 4: Locating Nuts
Courtesy of FORD MOTOR CO.
Install the clamps.

Fig 5: Locating Clamps
Courtesy of FORD MOTOR CO.
Recheck the toe settings, adjust as necessary.