Connecting Rod Bearings: Installation
- Install the connecting rod bearings.
- Install the connecting rod bearing cap and 2 nuts.
- Tighten to 35 Nm (26 lb-ft).
- Repeat the procedure until all the connecting rod bearings are replaced.
- If removed, install the oil pump. For additional information, refer to ENGINE LUBRICATION COMPONENTS - EXPLODED VIEW, OIL PAN, OIL PAN BAFFLE AND OIL PUMP and OIL PUMP in this article.
- Install the oil pan. For additional information, refer to ENGINE LUBRICATION COMPONENTS - EXPLODED VIEW, OIL PAN, OIL PAN BAFFLE AND OIL PUMP and OIL PAN in this article.
CAUTION:
The connecting rod bearings are precision fit. For additional information, refer to ENGINE SYSTEM-GENERAL INFORMATION
for checking clearances or bearing selection.
CAUTION:
The connecting rod bearings must be lubricated with clean engine oil prior to installation or damage to the connecting rod bearing may occur.