LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Ranger 2D Pickup, 3.0 U, 4WD, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Disassembly And Assembly Of Subassemblies >> Front Planetary Gears >> Assembly

Front Planetary Gears: Assembly

    NOTE:
    1. Thoroughly clean all parts and blow dry with moisture free compressed air.
    2. Use petroleum jelly to hold the front planetary thrust bearing (No. 2) in place.
    Fig 1: Locating No. 2 Front Planetary Thrust Bearing
    G04702248Courtesy of FORD MOTOR CO.
  1. Install the No. 2 front planetary thrust bearing.
  2. Install the front planetary gear carrier into the center shaft and front ring gear.
    Fig 2: Locating Front Planetary Gear Carrier
    G04702249Courtesy of FORD MOTOR CO.
    3. CAUTION: Make sure that the No. 12 bearing is in place in the front planetary prior to installing the front sun gear.
    Fig 3: Locating Overdrive Sun Gear
    G04702250Courtesy of FORD MOTOR CO.
  3. Install the front sun gear with the recessed gear teeth facing toward the adapter.
    4. CAUTION:
    1. The part number that is stamped on the coast clutch adapter must face toward the front sun gear or the coast clutch assembly will not fit into the transmission.
    2. Use care not to bend or damage the exciter wheel.
  4. Install the front sun gear.
    1. Install the front sun gear.
    2. Install the coast clutch to front carrier adapter.
      Fig 4: Identifying Front Sun Gear
      G04702251Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals