LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Ranger 2D Pickup, 3.0 U, 4WD, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission External Controls >> Diagnosis And Testing >> External Controls >> Symptom Table

Symptom Table

SYMPTOM TABLE

Condition Possible Sources Action
  • Shift interlock system does not release/lock correctly
  • Circuit(s)
  • Fuse(s)
    • F2.20 (10A)
    • F2.32 (5A)
  • Shift lock actuator
  • Brake pedal position (BPP) switch
  • Shift control is out of correct gear relationship
  • Transmission shift cable and bracket
  • Retainer bracket
  • Shift control linkage
  • Transmission range indicator does not correspond to the gear
  • Transmission shift cable bracket
  • TIGHTEN bolts holding transmission shift cable bracket.
  • Transmission control indicator linkage
  • ADJUST PRNDL at the steering housing.
  • Transmission shift cable loose from the transmission retainer bracket
  • REINSTALL transmission shift cable into bracket. INSTALL a new cable if damaged.
  • Shift linkage
  • Transmission shift cable loose from the column bracket
  • Column shift cable bracket
  • Clip securing the transmission shift cable to the shift control selector lever
  • INSTALL the clip correctly.
  • Internal transmission damage
  • Transmission range indicator lamp does not illuminate
  • Bulb
  • Circuit(s)
  • Transmission control (TC) switch is not operating correctly
  • Blown fuse(s)
    • I/P 26 (10A)
    • I/P 27 (15A)
  • Damaged TC switch or TC switch not cycled during self-test
  • Damaged powertrain control module
  • Internal transmission concerns
  • Circuity open/shorted
  • Transmission control indicator lamp (TCIL) does not illuminate
  • Burned-out bulb
  • Circuitry open/shorted
  • Damaged powertrain control module
  • Transmission control indicator lamp (TCIL) stays illuminated or flashes
  • Circuitry open/shorted
  • Damaged powertrain control module
  • Transmission error detected
  • Rattle, noise, buzz or other noise
  • Selector lever knob
  • INSTALL a new selector lever knob.
  • Shift control selector lever
  • TIGHTEN housing bolts.
  • Shift interlock spring
  • ATTACH shift interlock spring correctly.
  • Water enters inside the vehicle
  • Cable assembly grommet
  • SECURE grommet to dash panel.
  • Torn cable assembly grommet
  • INSTALL a new transmission shift cable.
  • Excessive shift effort
  • Cable bracket
  • ADJUST cable. TIGHTEN cable bracket screws.
  • Transmission shift cable
  • INSTALL a new transmission shift cable.
  • Transmission range selector lever will not shift
  • Transmission shift cable
  • REINSTALL transmission shift cable.
  • Lock tab
  • REPAIR/INSTALL a new lock tab.
  • Broken transmission shift cable
  • INSTALL a new transmission shift cable.
  • Internal transmission concerns