Removal and Installation
WARNING:
The safety belt pretensioner is a pyrotechnic device. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
WARNING:
Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
WARNING:
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
NOTE:
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Remove the affected seat and depower the SRS. For additional information, refer to SEAT - FRONT in this article.
- Disconnect the heated seat module electrical connector.
- Detach and remove the heated seat module.
- To install, reverse the removal procedure.
- Install the affected seat and repower the SRS. For additional information, refer to SEAT - FRONT in this article.