LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Freestar Base >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Removal And Installation >> Speed Control Cable >> Installation

Speed Control Cable: Installation

    NOTE: Incorrect wrapping of the speed control cable core wire around the speed control actuator pulley may result in a high idle condition.
  1. Insert the speed control cable slug into the speed control actuator pulley slot.
    1. Gently push the retaining spring.
    2. Insert the speed control cable slug completely into the speed control actuator pulley slot.
      Fig 1: Inserting Speed Control Cable Slug
      G04661911Courtesy of FORD MOTOR CO.
    2. NOTE: Make sure the rubber seal is correctly seated onto the speed control cable cap.
    Fig 2: Aligning Speed Control Cable Cap Tabs With Slots
    G04661912Courtesy of FORD MOTOR CO.
  2. Align the speed control cable cap tabs with the slots in the speed control actuator housing and seat the speed control cable cap.
  3. Rotate the speed control cable cap clockwise until the locking tab engages.
    Fig 3: Rotating Speed Control Cable Cap
    G04661913Courtesy of FORD MOTOR CO.
    4. NOTE: Make sure the tabs on the speed control cable are locked in place and that the cable is fully seated in the bracket.
  4. Install the speed control cable on the throttle bracket.
  5. Connect the speed control cable to the throttle lever end.
  6. Install the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
scientia non olet · About LEMON Manuals