Section 1 (Manual Transmission): Installation: Transaxle: Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.

CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled on a painted or plastic surface, wash the affected area immediately with cold water.

NOTE: Install a new intermediate shaft center bearing cap and locknuts.

NOTE: Install a new halfshaft snap ring.

NOTE: Make sure to align the index marks on the subframe to the chassis.

To install, reverse the removal procedure. For additional information, refer to TRANSAXLE .
- Check and, if necessary, fill the transmission with the specified fluid. The total fill capacity is 4.0 pints (1.9L). Apply sealant to the fill plug threads and install the fill plug.
- Fill the brake fluid reservoir to the specified level. Bleed the clutch hydraulic system. For additional information, refer to MANUAL TRANSAXLE-TRANSMISSION AND CLUTCH - GENERAL INFORMATION .
- Fill and bleed the power steering system. For additional information, refer to STEERING SYSTEM-GENERAL INFORMATION .
- An audible click will be heard when the gearshift cables are correctly seated in the retaining bracket.
- Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE-TRANSMISSION AND CLUTCH - GENERAL INFORMATION .