LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Expedition 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Repair >> Extension Housing Seal >> Installation

Extension Housing Seal: Installation

    NOTE: When installing the new seal, make sure that the drain hole in the seal is in the 6 o'clock position.
    Fig 1: Identifying Special Tools On Extension Housing Seal
    G04628271Courtesy of FORD MOTOR CO.
  1. Using the special tool, install a new extension housing seal.
    2. NOTE: The output shaft and the driveshaft are a balanced assembly.
  2. Install the driveshaft.
    • Align all the index marks and position the driveshaft on the transmission.
    • Install the driveshaft.
      Fig 2: Installing Drive Shaft
      G03888592Courtesy of FORD MOTOR CO.
    3. NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.
  3. Install the rear driveshaft and the 4 bolts.
    • Tighten to 103 N.m (76 lb-ft).
      Fig 3: Identifying Driveshaft Bolts
      G04016647Courtesy of FORD MOTOR CO.
  4. Check the level of the transmission fluid, add clean automatic transmission fluid as necessary.
scientia non olet · About LEMON Manuals