LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Expedition 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Repair >> Digital Transmission Range (TR) Sensor >> Removal

Digital Transmission Range (TR) Sensor: Removal

NOTE: The manual control lever must be in the NEUTRAL position.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING 2005JACKING & LIFTING 2006 .
    2. CAUTION: Do not pry on the swivel tube to disconnect the transmission shift linkage.
    Fig 1: Locating Selector Lever Cable
    G04628311Courtesy of FORD MOTOR CO.
  2. Disconnect the selector lever cable.
  3. Disconnect the digital TR electrical connector.
    Fig 2: Locating Digital TR Electrical Connector
    G04628312Courtesy of FORD MOTOR CO.
    4. CAUTION: Discard the outer manual control lever shaft nut. Do not reuse. The old nut will not retain the torque specification.
  4. Remove the manual control lever.
    1. Remove and discard the manual control nut.
    2. Remove the manual control lever.
      Fig 3: Identifying Manual Control Lever Nut
      G04628313Courtesy of FORD MOTOR CO.
  5. Remove the digital TR sensor bolts and the digital TR sensor.
    Fig 4: Identifying Digital TR Sensor And Bolts
    G04584370Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals