LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Escape Base, 2.3 Z, FWD, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Cd4E >> Disassembly And Assembly Of Subassemblies >> Main Control Valve Body >> Disassembly

Main Control Valve Body: Disassembly

  1. Remove the manual valve.
    Fig 1: Locating Manual Valve
    G04620285Courtesy of FORD MOTOR CO.
    2. CAUTION: Do not attempt to remove the solenoid valve body wiring cover.
    Fig 2: Locating Solenoid Valve Body
    G04620286Courtesy of FORD MOTOR CO.
  2. Remove the 2 solenoid valve body bolts and the solenoid valve body.
  3. Remove and discard the solenoid valve body gasket.
    Fig 3: Removing Solenoid Valve Body Gasket
    G04620287Courtesy of FORD MOTOR CO.
  4. Remove the 3 pressure tap plate bolts and the pressure tap plate.
    Fig 4: Locating Pressure Tap Plate Bolts
    G04620288Courtesy of FORD MOTOR CO.
  5. Remove and discard the pressure plate tap gasket.
    Fig 5: Locating Pressure Plate Tap Gasket
    G04620289Courtesy of FORD MOTOR CO.
  6. Remove the control valve body to transfer plate bolts, and remove the manual valve detent spring assembly.
    Fig 6: Locating Control Valve Body Transfer Plate Bolts
    G04620290Courtesy of FORD MOTOR CO.
  7. Remove the accumulator body-to-transfer plate bolts.
    Fig 7: Locating Accumulator Body-To-Transfer Plate Bolts
    G04620291Courtesy of FORD MOTOR CO.
  8. Separate the accumulator body from the main control valve body.
    1. Remove the accumulator body assembly.
    2. Remove and discard the accumulator body separator gasket.
    3. Remove the accumulator body separator plate.
    4. Remove and discard the accumulator body separator gasket.
    5. Remove the main control valve body.
      Fig 8: Identifying Accumulator Body Assembly
      G04620292Courtesy of FORD MOTOR CO.
  9. Separate the transfer plate from the main control valve body.
    1. Remove the main control valve body.
    2. Remove and discard the valve body separator plate gasket.
    3. Remove the valve body separator plate.
    4. Remove and discard the valve body separator plate gasket.
    5. Remove the transfer plate.
      Fig 9: Identifying Transfer Plate Main Control Valve Body Parts
      G04620293Courtesy of FORD MOTOR CO.
  10. Remove the intermediate and overdrive accumulator valve plug retaining plate from the accumulator body assembly.
    Fig 10: Locating Intermediate & Overdrive Accumulator Valve Plug Retaining Plate
    G04620294Courtesy of FORD MOTOR CO.
  11. Remove the intermediate and overdrive accumulator valve plug.
    Fig 11: Locating Intermediate & Overdrive Accumulator Valve Plug
    G04620295Courtesy of FORD MOTOR CO.
  12. Remove and discard the intermediate and overdrive accumulator plug seal.
    Fig 12: Locating Intermediate & Overdrive Accumulator Plug Seal
    G04620296Courtesy of FORD MOTOR CO.
    13. CAUTION: Remove, note location and clean one valve at a time to avoid incorrect installation.
  13. As necessary, disassemble the parts of the accumulator body and main control valve body assemblies.
    • Lubricate and reassemble the parts as soon as possible to avoid accidental damage or incorrect installation.
scientia non olet · About LEMON Manuals