LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2006 >> Cutaway 6.0 P >> Repair and Diagnosis >> External Pages >> Different car >> Section 562 (Electronic Engine Controls) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation

Powertrain Control Module (PCM): Installation

WARNING: This page is about a different car, the 2006 Mercury Mountaineer and 2006 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Install the PCM and bolts.
    • Tighten to 10 Nm (89 lb-in).
  2. Connect the PCM electrical connectors.
  3. Position the wiring harness and the A/C tube brackets and install the nuts. Connect the RH front wheel speed sensor electrical connector.
    • Tighten to 7 Nm (62 lb-in).
      Fig 1: Locating Nuts And RH Front Wheel Speed Sensor Electrical Connector
      G04639304Courtesy of FORD MOTOR CO.

    4. Vehicles equipped with a 4.6L (3V) engine 

  4. Install the air cleaner. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .

    5. All vehicles 

  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION .
  6. Reprogram the passive anti-theft system (PATS). Carry out the Parameter Reset procedure. For additional information, refer to ANTI-THEFT - PATS .
scientia non olet · About LEMON Manuals