LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> In-Vehicle Repair >> Extension Housing Seal >> Removal

Extension Housing Seal: Removal

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the driveshaft. For additional information, refer to DRIVESHAFT .
  3. Using a suitable transmission jack, support the transmission.
  4. Remove the 4 transmission crossmember-to-floor pan screws only and lower the transmission enough to gain access to the extension housing seal.
    Fig 1: Removing Transmission Crossmember-To-Floor Pan Screws
    G03982786Courtesy of FORD MOTOR CO.
  5. Remove and discard the nut.
    Fig 2: Removing Nut
    G03985155Courtesy of FORD MOTOR CO.
  6. Using the special tool, remove the output shaft flange.
    Fig 3: Removing Output Shaft Flange
    G03985151Courtesy of FORD MOTOR CO.
  7. Using the special tools, remove and discard the extension housing seal.
    Fig 4: Removing Extension Housing Seal
    G03948865Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals