Front Toe Adjustment

NOTE: The checking and subsequent adjustment of the front toe setting should be carried out on a flat surface and in accordance with the manufacturers instructions for the wheel alignment equipment used.

Center the steering and lock it in position.

Fig 1: Identifying Steering And Lock It In Center Position
Courtesy of FORD MOTOR CO.
Loosen the tie-rod end locknuts.

Fig 2: Loosening Tie-Rod End Locknuts
Courtesy of FORD MOTOR CO.
Remove the steering gear boot outer clamps.

Fig 3: Removing Steering Gear Boot Outer Clamps
Courtesy of FORD MOTOR CO.
Rotate the tie-rods an equal amount in either a clockwise or a counterclockwise direction to adjust the toe setting.

Fig 4: Rotating Tie-Rods To Adjust Toe Setting
Courtesy of FORD MOTOR CO.
Tighten the tie-rod end locknuts. For additional information, refer to STEERING LINKAGE .

Fig 5: Tightening Tie-Rod End Locknuts
Courtesy of FORD MOTOR CO.
Install the steering gear boot outer clamps.

Fig 6: Installing Steering Gear Boot Outer Clamps
Courtesy of FORD MOTOR CO.
Check the toe setting.