Inspection and Verification
WARNING:
When working underhood in the vicinity of the starter motor, be aware that the heavy gauge battery input lead at the starter solenoid is "electrically hot" at all times. A protective cap or boot is provided over the terminal of this lead and must be reinstalled after repairing
WARNING:
When working in the area of the starter motor, be careful to avoid touching hot exhaust components.
NOTE:
The anti-theft system must be functioning correctly before a logical starting system diagnosis can be carried out. Address anti-theft concerns before continuing.
- Verify the customer concern.
- Visually inspect for obvious signs of mechanical or electrical damage.VISUAL INSPECTION CHART
Mechanical Electrical - Starter motor
- Battery
- Fuse(s)
- Wiring harness
- Starter relay
- Loose or corroded connections
- Anti-theft system
- Starter switch (manual transaxle only)
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the cause is not visually evident, verify the symptom. GO to SYMPTOM CHART .