LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Expedition RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 494 (Speed Control) >> Removal And Installation >> Speed Control Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Lincoln Navigator and 2006 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Remove the driver air bag module. For additional information, refer to REMOVAL .

    2. Expedition 

  2. Remove the 2 screws and the speed control switch.
    • Disconnect the electrical connector.

    3. Navigator 

  3. Remove the horn switch.
    1. Disconnect the electrical connector.
    2. Remove the 4 bolts.
      Fig 1: Locating Electrical Connector Bolts
      G04629135Courtesy of FORD MOTOR CO.
  4. Remove the speed control switch.
    1. Disconnect the wiring harness locators.
    2. Remove the 4 screws.
      • To install, tighten to 7 N.m (62 lb-in).
        Fig 2: Locating Wiring Harness Locators Screws
        G04629136Courtesy of FORD MOTOR CO.

    5. All vehicles 

  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals