Speed Control Actuator: Installation

CAUTION: A new speed control cable must be installed.

Install the speed control actuator and the 3 speed control actuator screws.
- Tighten to 9 Nm (80 lb-in).
- Connect the electrical connector.
Insert the speed control cable slug into the speed control actuator pulley slot.
1. Gently push the retaining spring.
2. Insert the speed control cable slug completely into the speed control actuator pulley slot.
  
  Fig 1: Inserting Speed Control Cable Slug Into Speed Control Actuator Pulley Slot
  Courtesy of FORD MOTOR CO.

CAUTION: It is necessary to squarely seat the speed control cable cap and seal around the speed control actuator pulley.

CAUTION: Incorrect wrapping of the speed control cable around the speed control actuator pulley may result in high idle conditions.

NOTE: Make sure the rubber seal is fully seated onto the speed control cable cap.

Fig 2: Aligning Speed Control Cable Cap Tabs With Slots In Speed Control Actuator Housing

Courtesy of FORD MOTOR CO.

Align the speed control cable cap tabs with the slots in the speed control actuator housing.
Rotate the speed control cable cap until the locking tab engages.

Fig 3: Rotating Speed Control Cable Cap Until Locking Tab Engages
Courtesy of FORD MOTOR CO.