Connect - III

CAUTION: Make sure the tube clicks into place when installing into the quick connect coupling. To make sure the tube is fully seated, pull on the tube.

NOTE: Apply clean engine oil to the O-ring seals.

Fig 1: Installing Quick Connect Coupling Onto Tube Until Fully Seated

Courtesy of FORD MOTOR CO.

Install the quick connect coupling onto the tube until fully seated.

CAUTION: Make sure the retainer clip clicks into place when installing.

Fig 2: Depressing Retainer Clip Until It Is Flush With Quick Connect Coupling Housing

Courtesy of FORD MOTOR CO.

Depress the retainer clip until it is flush with the quick connect coupling housing.

CAUTION: To make sure the tube is fully seated, pull on the quick connect coupling.

Rotate the primary locking tab to the closed position