Instrument Cluster DTCS
INSTRUMENT CLUSTER DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Source | Perform Test |
|---|---|---|---|
| B1202 | Fuel Sender Circuit Open | Instrument Cluster | GO to PINPOINT TEST B . |
| B1204 | Fuel Sender Circuit Short to Ground | Instrument Cluster | GO to PINPOINT TEST B . |
| B1205 | Reset Button Circuit Failure | Instrument Cluster | VERIFY that the instrument cluster bezel is aligned correctly and the SELECT/RESET button is not binding. REPAIR as necessary. If the switch is not binding, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . |
| B1317 | Battery Voltage High | Instrument Cluster | REFER to CHARGING SYSTEM - GENERAL INFORMATION . |
| B1318 | Battery Voltage Low | Instrument Cluster | REFER to CHARGING SYSTEM - GENERAL INFORMATION . |
| B1319 | Driver Door Ajar Circuit Failure | Instrument Cluster | GO to PINPOINT TEST W . |
| B1327 | Passenger Door Ajar Circuit Failure | Instrument Cluster | GO to PINPOINT TEST W . |
| B1342 | ECU Is Faulted | Instrument Cluster |
NOTE:
If other DTCs are present, REPAIR them before installing a new component. CLEAR the DTCs. RETRIEVE the DTCs. If DTC B1342 is retrieved again, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER
. REPEAT the self-test. |
| B1352 | Ignition Key-In Circuit Failure | Instrument Cluster | REFER to WARNING DEVICES . |
| B1360 | Ignition Run/Ace Circuit Open | Instrument Cluster | GO to PINPOINT TEST A . |
| B1607 | Illuminated Entry Input Circuit Failure | Instrument Cluster | REFER to INTERIOR LIGHTING . |
| B2143 | Non-Volatile Memory Failure | Instrument Cluster | INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . REPEAT the self-test. |
| B2477 | Module Configuration Failure | Instrument Cluster | ATTEMPT to configure the instrument cluster again. If DTC B2477 is retrieved again, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . REPEAT the self-test. |
| B2658 | Wait to Start Warning Indicator Circuit Open | Instrument Cluster | CARRY-OUT the instrument cluster dealer test mode. If the wait to start indicator proves out normally, See INTRODUCTION - GASOLINE article . Otherwise, INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . |
| B2982 | Park Brake Switch Input Circuit Open | Instrument Cluster | GO to PINPOINT TEST J . |
| P1139 | Water in Fuel Indicator Circuit Open | Instrument Cluster | See INTRODUCTION - GASOLINE article . |
| U0002 | High Speed CAN Communication Bus Performance | Instrument Cluster | REFER to MODULE COMMUNICATIONS NETWORK . |
| U1900 | CAN Communication Bus Fault-Receive Error | Instrument Cluster | REFER to MODULE COMMUNICATIONS NETWORK . |
| U2023 | Fault Received From External Node | Instrument Cluster | REFER to MODULE COMMUNICATIONS NETWORK . |