Door Locks: Anti-Theft
- Specifications
- Description And Operation
- Diagnosis And Testing
- Anti-Theft
- Passive Anti-Theft System (PATS) - Inspection And Verification
- Passive Anti-Theft System (PATS) - Diagnostic Trouble Codes (DTC) Index
- Passive Anti-Theft System (PATS) - Diagnostic Trouble Codes (DTC) Descriptions
- Passive Anti-Theft System (PATS) - Symptom Chart
- Passive Anti-Theft System (PATS) - Pinpoint Tests
- Connector Circuit Reference
- Pinpoint Test A: The Anti-Theft Indicator Is Never On - No Three-Second Theft Indicator Prove-out
- Pinpoint Test B: The Anti-Theft System Does Not Operate Correctly - The Vehicle Starts But Flashes Rapidly At Key On
- Pinpoint Test C: The Anti-Theft System Does Not Operate Correctly - Anti-Theft Number Of Programmed Keys Is Below Minimum
- Pinpoint Test D: Data Mismatch (Received Data Does Not Match What Was Expected)
- Pinpoint Test E: The Anti-Theft System Does Not Operate Correctly - NVM Configuration Failure (No PCM ID Exchanged Between Instrument Cluster And PCM)
- Pinpoint Test F: The Anti-Theft System Does Not Operate Correctly - PATS Ignition Key Transponder Signal Is Not Received Or Transponder Programming Failed (Damaged Key Or Non-PATS Key)
- Pinpoint Test G: The Anti-Theft System Does Not Operate Correctly - PATS Received Incorrect Key-Code From Key Transponder (Unprogrammed PATS Key)
- Pinpoint Test H: The Anti-Theft System Does Not Operate Correctly - PATS Received Invalid Format Of Key-Code From Key Transponder (Partial Key Read)
- Pinpoint Test I: The Anti-Theft System Does Not Operate Correctly - PATS Transceiver Signal Is Not Received (Not Connected, Damaged, Or Wiring)
- Pinpoint Test J: The Anti-Theft System Does Not Operate Correctly - Antenna Not Connected Or Defective Transceiver
- Pinpoint Test K: The Vehicle Does Not Start - Theft Indicator Does Not Prove Out And Flashes Rapidly
- Anti-Theft - Perimeter
- Notes
- Special Tool(s)
- Inspection And Verification
- FEM Diagnostic Trouble Code (DTC) Index
- REM Diagnostic Trouble Code (DTC) Index
- RKE Diagnostic Trouble Code (DTC) Index
- Symptom Chart
- Connector Circuit Reference
- Pinpoint Test L: The Alarm System Does Not Operate Correctly - Lights Do Not Flash When Arming The System
- Pinpoint Test M: The Alarm System Does Not Disarm - Using The Driver Reset Switch
- Pinpoint Test N: The Alarm System Does Not Arm/Disarm - Using The Remote Transmitter
- Pinpoint Test O: The Alarm System Does Not Operate Correctly - Alarm Does Not Activate With Hood Ajar/Open
- General Procedures
- Removal And Installation