Removal and Installation

WARNING: This page is about a different car, the 2004 Mercury Marauder, 2004 Mercury Grand Marquis, and 2004 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Remove the air cleaner. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
Disconnect the anti-lock brake system (ABS) module electrical connectors.
- Disconnect the control module electrical connector.
- Disconnect the pump motor electrical connector.
Fig 1: Identifying Brake System (ABS) Module Electrical Connectors
Courtesy of FORD MOTOR CO.

NOTE: Do not pry the module from the hydraulic control unit (HCU).

Fig 2: Removing ABS Module

Courtesy of FORD MOTOR CO.

Remove the ABS module.
- Remove the screws in the sequence shown.
- Remove the module.

NOTE: Be sure the ABS module-to-HCU gasket is clean and installed correctly.

To install, reverse the removal procedure.