Removal and Installation

Remove the stabilizer bar. For additional information, refer to STABILIZER BAR .

CAUTION: The axle must be supported throughout the procedure to prevent strain on the front brake hose. If the disc brake caliper must be removed for additional clearance, refer to DISC & DRUM article for additional information.

Use a suitable jack to support the affected front axle.
Remove the nut and disconnect the shock absorber.

Fig 1: Disconnecting Shock Absorber
Courtesy of FORD MOTOR CO.
Remove the bolt and the upper spring retainer.

Fig 2: Removing Upper Spring Retainer
Courtesy of FORD MOTOR CO.
Lower the jack supporting the front axle and remove the front coil spring.

Fig 3: Removing Front Coil Spring
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.