LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> ZX2 Standard >> Repair and Diagnosis >> Body & Frame >> Seats >> Seating >> Disassembly And Assembly >> Seat-Child Safety, Base >> Assembly

Seat-Child Safety, Base: Assembly

WARNING: All built-in child restraints, including seats, buckles, retractors, seat latches, interlocks, and attaching hardware should be inspected by a qualified dealer technician after any collision. If the child seat was in use during a collision, ford recommends replacing it. However, if the collision was minor and a qualified technician finds that the child restraints do not show damage and continue to operate properly, they do not need to be replaced. Built-in child seats not in use during a collision should also be inspected and replaced if either damage or improper operation is noted.
  1. Install booster pad number 1.
    1. Position booster pad number 1.
    2. Invert the child safety seat trim cover.
    Fig 1: Inverting Child Safety Seat Trim Cover
    G01373980Courtesy of FORD MOTOR CO.
  2. Install booster pad number 2.
    1. Position booster pad number 2.
    2. Invert the child safety seat trim cover.
    Fig 2: Inverting Child Safety Seat Trim Cover
    G01373981Courtesy of FORD MOTOR CO.
  3. Install the hog rings.
    Fig 3: Installing Hog Rings
    G01373982Courtesy of FORD MOTOR CO.
  4. Connect the hook and loop strip.
    Fig 4: Connecting Hook And Loop Strip
    G01373983Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals