LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> ZX2 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Rear Suspension) >> Removal And Installation >> Axle >> Installation

Removal And Installation: Axle: Installation

WARNING: This page is about a different car, the 2003 Ford Windstar and 2002 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear spring lower insulators. Make sure the insulators are correctly seated.
  2. Install the jounce bumpers.
  3. Install the parking brake cable brackets.
  4. Install the spindle, hub and brake assemblies.
  5. Raise the rear axle assembly into position and install the trailing arm-to-subframe bolts.
  6. If removed, position the rear spring upper insulators on top of the springs.
  7. Install the rear springs on the rear axle assembly, making sure the spring is correctly seated.
  8. Raise the rear axle assembly using special tool 014-00942 or equivalent.
  9. Position the shock absorbers on the rear axle and install the bolts.
  10. Position the track bar on the axle and install the bolt.
  11. Remove special tool 014-00942 or equivalent.
  12. Install the parking brake cable and conduits in the brackets.
  13. Install the parking brake cable and conduits in the backing plates. Make sure the clips snap into place.
  14. Connect the parking brake cables to the parking brake levers.
  15. Connect the brake lines.
    1. Connect the fittings to the wheel cylinders.
    2. Install the bolts.
  16. Install the anti-lock brake sensors and the bolts.
  17. Install the brake drums. For additional information, refer to DISC & DRUM .
  18. Bleed the brakes. For additional information, refer to DISC & DRUM .
  19. Install the wheel and tire assemblies.
  20. Lower the vehicle.
scientia non olet · About LEMON Manuals