Removal and Installation

WARNING: This page is about a different car, the 2003 Mercury Marauder, 2003 Mercury Grand Marquis, and 2003 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Remove the ignition switch lock cylinder. For additional information, refer to STEERING COLUMN .
Remove the key-in-ignition warning switch.
1. Release the clip.
2. Push the key-in-ignition warning switch off the rear of the ignition switch lock cylinder.
Fig 1: Locating Release Clip
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.