LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Thunderbird >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Disassembly And Assembly >> Shock Absorber and Spring Assembly >> Disassembly

Shock Absorber and Spring Assembly: Disassembly

  1. Remove the shock absorber and spring assembly. For additional information, refer to SHOCK ABSORBER AND SPRING ASSEMBLY .
    2. CAUTION: Over-tightening the vise can damage the shock absorber tube.
  2. Mount and mark the shock absorber and spring assembly.
    1. Position the shock absorber and spring assembly in a suitable holding device.
    2. Mark the upper mount, spring and shock absorber for assembly reference.
      Fig 1: Mounting & Referencing Shock Absorber Spring
      G00374132Courtesy of FORD MOTOR CO.
    3. NOTE: If installing a new spring, make sure the part number is correct. Refer to the vehicle certification (VC) label for the correct spring code.
  3. Compress the spring.
    1. Install an appropriate spring compressor.
    2. Compress the spring.
  4. While holding the shock absorber rod, remove and discard the nut.
    Fig 2: Removing Shock Absorber Rod Nut
    G00374134Courtesy of FORD MOTOR CO.
  5. Remove the upper mount and dust boot as an assembly.
    Fig 3: Removing Upper Shock Absorber Mount & Dust Boot
    G00374135Courtesy of FORD MOTOR CO.
  6. Carefully remove the spring and spring compressor.
    Fig 4: Removing Spring & Spring Compressor
    G00374136Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals