MULTIFUNCTION Switch
WARNING: This page is about a different car, the 2002 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect multifunction switch 10-pin harness connector C441 (remove wiper switch if necessary). Check continuity between wiper switch terminals with switch in specified position. See WIPER SWITCH CONTINUITY table. See Figure. If continuity is not as specified, replace wiper switch. See MULTIFUNCTION SWITCH under REMOVAL & INSTALLATION.
MULTIFUNCTION SWITCH CONTINUITY
| Switch Position | Continuity Between Terminals No. | |||
|---|---|---|---|---|
| Front Wiper | ||||
| Off | 7 & 9 | |||
| Single Wipe | 6 & 9 | |||
| Normal | 6 & 9 | |||
| High | 6 & 8 | |||
| Intermittent | (1) 6 & 10; 7 & 9 | |||
| Rheostat Variable | (1) 1 & 10 | |||
| Rear Wiper | ||||
| Off | 3 & 5; 4 & 6 | |||
| On | 4 & 6; 5 & 6 | |||
| Washer | ||||
| Off | 2 & 6 | |||
| Front | 2 & 3 | |||
| Rear | 3 & 4; 5 & 6 | |||
|
||||