Test E: Speed Control Does Not Disengage With Clutch Applied
WARNING: This page is about a different car, the 2002 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Turn ignition off. Disconnect Clutch Pedal Position (CPP) switch. Measure resistance between CPP switch connector C825 terminals No. 1 and 3 (component side). See Figure. Press and release clutch pedal. Resistance should be greater than 10 k/ohms with clutch pedal depressed and less than 5 ohms when released. If resistance is as specified, adjust CPP switch. If resistances are not as specified, replace CPP switch. Retest system operation.