AUTOLOCK (Enable/Disable)
- Close all doors and ensure ignition switch is in the OFF position.
NOTE:
Steps 2- 4 must be completed within 30 seconds or procedure must be repeated.
- Turn ignition switch to ON position. Press UNLOCK button 3 times.
- Turn ignition switch to OFF position. Press UNLOCK button 3 times.
- Turn ignition switch to ON position. Press UNLOCK button 3 times.
- Horn will chirp to indicate program mode has been entered. If horn does not chirp, repeat steps 2- 4.
- Press UNLOCK button one time to toggle autolock between enabled and disabled.
- Press LOCK button one time to enter the command.
- One horn chirp indicates that the autolock has been disabled. If one horn chirp followed by a longer horn sound is heard, this indicates that the autolock has been enabled. If state of autolock is not correct, go to step 7 and repeat procedure from that point.
- To exit programming mode, turn ignition switch to OFF position. Once programming is complete, exit vehicle and close door. The horn will chirp one time to confirm that the autolock state has been changed.