LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Cutaway 5.4 M >> Repair and Diagnosis >> Engine Mechanical >> Starting System - Starters - Except Diesel >> Component Tests >> Starter No-Load Test

Starter No-Load Test

WARNING: Ensure starter motor is securely mounted on bench as starter motor may move or jump when energized.
  1. Remove starter motor. See STARTER MOTOR  under REMOVAL & INSTALLATION. Connect remote starter switch between positive battery terminal and starter motor solenoid terminal "S". See Figure. Jumper starter motor "B" terminal to positive battery post. Connect charging/starting system tester according to manufacturer's instructions. Ensure battery and starter motor are grounded.
  2. Engage remote starter switch. Starter should eject starter drive and turn smoothly. DVOM should indicate 11 volts or more, and ammeter should indicate 70 amps. If voltage is lower or current is higher than specification, replace starter motor. See STARTER MOTOR  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals