Air Line Fluid Purge
WARNING:
Do not remove an air spring under any circumstances when there is pressure in the air spring. Do not remove any components supporting an air spring without either exhausting the air or providing support for the air spring to prevent vehicle damage or personal injury.
WARNING:
Disconnecting an air line that is connected to the air compressor can cause personal injury or damage to components as high pressure air is vented uncontrolled.
- Disconnect the air line at the air compressor drier.
- Disconnect the air line from the air springs.
- Connect a shop air line to the disconnected air line and blow any fluid out.
- Reconnect the air lines at the air springs.
- Replace the air compressor drier. For additional information, refer to DRIER - AIR COMPRESSOR .
- Reconnect the air line to the air compressor drier.
- Ensure that all air line fittings are sealed.
NOTE:
Perform this procedure if fluid (water and/or oil) is found in the air line. Purge fluid from rear air lines and replace affected components.
NOTE:
When installing the air lines, make sure the white air line is fully inserted into the fitting for correct installation.