LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Ranger 2D Pickup, 2.3 D, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Anti-Theft Systems - Passive >> Programming >> Key Programming - Using 2 Programmed Keys

Key Programming - Using 2 Programmed Keys

NOTE: Procedure requires 2 programmed encoded keys and one or more new unprogrammed encoded keys.
  1. Insert first programmed encoded key into ignition switch. Turn ignition switch to ON position. Keep ignition switch in ON position for 3 seconds. Turn ignition switch to OFF position. Remove first programmed encoded key. Within 5 seconds, insert second programmed encoded key into ignition switch.
  2. Turn ignition switch from OFF to ON position. Keep ignition switch in ON position for 3 seconds. Turn ignition switch to OFF position. Remove second programmed encoded key. Within 20 seconds of removing second programmed encoded key, insert NEW unprogrammed encoded key into ignition switch. Turn ignition switch to ON position. Keep ignition switch in ON position for 3 seconds. Turn ignition switch to OFF position. Attempt to start vehicle. To program more encoded keys, repeat procedure from step  1 .
  3. If programming was successful, THEFT indicator light will illuminate for 3 seconds, then go out and vehicle engine can be started. If procedure was not successful, THEFT indicator light will flash on and off and vehicle engine cannot be started. If procedure is not successful, wait at least one minute, then repeat entire procedure from step  1 .
scientia non olet · About LEMON Manuals