LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Mustang Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transmission) >> In-Vehicle Repair >> Transmission Support CROSSMEMBER >> Removal and Installation

Removal and Installation

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle.
  2. Support the transmission with a suitable transmission jack.
  3. Remove the crossmember.
    1. Disconnect the HO2S sensors and position them aside.
    2. Remove the bolts from the crossmember to the extension housing.
    3. Remove the bolts from the crossmember to the body and remove the crossmember.
      Fig 1: Removing Bolts From Crossmember To Extension Housing
      G03402092Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals