Restraints Control Module (RCM): Installation
WARNING: This page is about a different car, the 2005 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Position the RCM and install the nuts.
- To install, tighten to 12 Nm (9 lb-ft)
- Connect the small RCM electrical connector.
- Make sure the large RCM connector position assurance lever is in the full RELEASE position before attempting to connect the connector.
- Connect the large RCM electrical wiring connector.
- Using the connector position assurance lever, pivot it toward the RCM, drawing the connector into the RCM.
- Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
- Using the connector position assurance lever, pivot it toward the RCM, drawing the connector into the RCM.
- Connect the electrical connectors and install the center instrument panel finish panel and the 6 screws.
- Install the driver and passenger center console kick panels.
- Install the center console top finish panel and the 2 screws.
- Install the console shifter bezel.
- Repower the system. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .
WARNING:
The tightening torque of the air bag restraints control module (RCM) retaining nuts is critical for correct system operation.
CAUTION:
Putting the large RCM electrical wiring connector into the RCM on an angle can cause bad electrical connections and damage components.
CAUTION:
Do not push the connector to where the lever pivots and seats itself. Light pressure is needed to get the connector into position on the RCM before using the lever to fully seat the connector.
NOTE:
A similar RCM and connectors are shown.