LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Excursion 5.4 L, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine - 6.8L V10) >> Overhaul >> Cylinder Block Assembly >> Cylinder Block

Cylinder Block

WARNING: This page is about a different variant/trim than selected.
  1. Using a feeler gauge and straightedge, inspect cylinder block deck for warpage. If not within specification, resurface or replace cylinder block. See CYLINDER BLOCK  table under ENGINE SPECIFICATIONS.
    CAUTION: DO NOT machine more than .010" (.025 mm) from original cylinder block head surface.
  2. Check cylinder bore diameter, out-of-round and taper. Cylinder bore is measured at .50" (12.7 mm) below top of cylinder block head surface and .50" (12.7 mm) above piston when at bottom of cylinder bore.
  3. Bore cylinder block if measurements are not within specification. See CYLINDER BLOCK  table under ENGINE SPECIFICATIONS.
scientia non olet · About LEMON Manuals