Description & Operation

WARNING: Vehicles are equipped with air bag supplemental restraint system. Before attempting any repairs involving instrument panel, seats, steering column, or related components, see SERVICE PRECAUTIONS and DISABLING & ACTIVATING AIR BAG SYSTEM in appropriate AIR BAG RESTRAINT SYSTEMS article.

The driver 6-way power driver's seat provides horizontal, vertical and tilt adjustments. System consists of driver seat control switch, driver seat motor assembly, vertical and horizontal screw drives and gear mechanism, housing assembly and necessary wiring. Driver seat control switch is mounted on outside seat trim panel. Power seat circuits are protected by fuse No. 21 (40-amp), located in Battery Junction Box (BJB) and fuse No. 26 (30-amp), located in Central Junction Box (CJB). BJB is located in left front corner of engine compartment. CJB is located behind left side kick panel.

Horizontal movement is controlled by a transmission, lead screw and motor attached to the movable section of the track. Vertical drive unit is located on left side of the movable track. Vertical operation energizes center and rear armatures and vertical drive units move seat up or down. In tilt operation, armatures move front or rear vertical drive screws to adjust seat. The regulator/motor unit is serviced as an assembly.

Driver and passenger side air bags are attached to seat backrest frame. Front seat backrest trim covers installed with side air bags cannot be repaired. A new seat backrest trim cover must be installed. Seatback can be cleaned. If a side air bag is deployed, replace seat back pad, trim cover and side air bag module. For information on air bag diagnosis, testing or disposal procedures, see appropriate lemon-25(R) AIR BAG SERVICE & REPAIR MANUAL, DOMESTIC & IMPORTED MODELS.