Test C: Single Mirror Inoperative With Switch Logic

Turn ignition switch to LOCK position. Disconnect suspect power mirror 6-pin harness connector. Turn ignition switch to RUN position. Measure voltage or resistance between ground and suspect power mirror harness connector specified terminals, while operating mirror control switch to specified positions. See POWER MIRROR CIRCUIT TEST table. See Figure . If any voltage or resistance is not as specified, go to next step. If all voltages or resistances are as specified, replace suspect power mirror.

POWER MIRROR CIRCUIT TEST

Power Mirror Harness Connector Terminal No.	Wire Color	Mirror Control Switch Position	Specification
Driver's
4	Red	Right	10 Volts Or More
4	Red	Left	Less Than 5 Ohms
6	Dark Blue	Down	10 Volts Or More
6	Dark Blue	Up	Less Than 5 Ohms
Driver's & Passenger's
5	Yellow	Up	10 Volts Or More
5	Yellow	Down	Less Than 5 Ohms
5	Yellow	Left	10 Volts Or More
5	Yellow	Right	Less Than 5 Ohms
Passenger's
4	Dark Green	Right	10 Volts Or More
4	Dark Green	Left	Less Than 5 Ohms
6	Violet	Down	10 Volts Or More
6	Violet	Up	Less Than 5 Ohms

Turn ignition switch to LOCK position. Disconnect mirror control switch 8-pin harness connector. Measure resistance between ground and suspect power mirror harness connector at specified terminals. See POWER MIRROR RESISTANCE TEST table. See Figure . If all resistances are 10 k/ohms or more, replace mirror control switch. If any resistance is less than 10 k/ohms, repair short to ground in appropriate wire(s).

POWER MIRROR RESISTANCE TEST

Power Mirror Harness Connector Terminal No.		Wire Color
Driver's
4		Red
5		Yellow
6		Dark Blue
Passenger's
4		Dark Green
5		Yellow
6		Violet