Test G: Off Switch Is Inoperative

Turn ignition switch to OFF position. Disconnect speed control servo Black 10-pin harness connector C146 located near master cylinder. While pressing OFF switch and rotating steering wheel from stop-to-stop, measure resistance between speed control servo Black 10-pin harness connector C146 terminals No. 5 (Light Blue/Black wire) and No. 6 (Dark Green/Orange wire). See Figure . If resistance is less than 5 ohms, replace speed control servo. See REMOVAL & INSTALLATION  . Retest system operation. If resistance is 5 ohms or more, replace speed control switch. See REMOVAL & INSTALLATION  . Retest system operation.