Test F: Res Switch Is Inoperative

Turn ignition switch to OFF position. Disconnect speed control servo Black 10-pin harness connector C146 located near master cylinder. While pressing RES switch and rotating steering wheel from stop-to-stop, measure resistance between speed control servo Black 10-pin harness connector C146 terminals No. 5 (Light Blue/Black wire) and No. 6 (Dark Green/Orange wire). See Figure . If resistance is 1980-2420 ohms, replace speed control servo. See REMOVAL & INSTALLATION  . Retest system operation. If resistance is not 1980-2420 ohms, replace speed control switch. See REMOVAL & INSTALLATION  . Retest system operation.