Lower Control Arm: Installation
WARNING: This page is about a different car, the 1999 Ford Mustang and 1998 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Manufacturer recommends replacing all nuts and bolts with NEW parts.
- To install, reverse removal procedure. Ensure lower end of spring is positioned between 2 holes in lower arm spring pocket. See Figure . On 4.6L engine, install upper plate between coils in location marked during removal. DO NOT nick spring coils when installing upper plate.
- Raise lower control arm to normal position before tightening attaching nuts. With vehicle at normal operating height, tighten remaining nuts and bolts to specifications. See TORQUE SPECIFICATIONS . After installation, check front end alignment and adjust if necessary. See appropriate SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.
NOTE:
Manufacturer recommends replacing all nuts and bolts with NEW parts.
To install, reverse removal procedure. With vehicle at normal operating height, tighten all and bolts to specification. See TORQUE SPECIFICATIONS . After installation, check front end alignment and adjust if necessary. See appropriate SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT.