Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.

Apply a bead of sealant to the keyway in the crankshaft damper and use the special tool to install the crankshaft pulley.

Fig 1: Installing Crankshaft Pulley
Courtesy of FORD MOTOR CO.
Raise the subframe into position and install the bolts.

Fig 2: Identifying Tightening Torque Of Subframe Bolt
Courtesy of FORD MOTOR CO.
Remove the safety stand.

Fig 3: Removing Safety Stand
Courtesy of FORD MOTOR CO.
Connect the anti-lock brake wheel speed sensor connector.

Fig 4: Locating Anti-Lock Brake Wheel Speed Sensor Connector
Courtesy of FORD MOTOR CO.
Install the crankshaft pulley bolt.

Fig 5: Identifying Tightening Torque Of Crankshaft Pulley Bolt
Courtesy of FORD MOTOR CO.
Install the splash shield.
- Install the pin-type retainers.
  
  Fig 6: Identifying Splash Shield
  Courtesy of FORD MOTOR CO.
Install the RH front wheel.
Lower the vehicle.
Install the accessory drive belt. For additional information, refer to ACCESSORY DRIVE .