LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 5.4 L, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Engine Controls - Remove/Install/Overhaul) >> Ignition System >> CMP Synchronizer >> Removal (3.0L VIN U & 2)

Removal (3.0L VIN U & 2)

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2000 Mercury Sable, 2000 Mercury Mystique, 2000 Mercury Grand Marquis, 2000 Mercury Cougar, and 2000 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Note position of CMP sensor electrical connector. Remove CMP sensor. See REMOVAL & INSTALLATION (3.0L VIN U & 2)  under CAMSHAFT POSITION SENSOR (CMP). Before removing CMP synchronizer assembly, set piston No. 1 to Top Dead Center (TDC) of compression stroke.
  2. Apply reference marks on CMP synchronizer assembly and engine. Remove CMP synchronizer assembly hold-down bolt and clamp. Remove CMP synchronizer assembly. Oil pump drive shaft may come out with synchronizer. If so, retrieve oil pump driveshaft before proceeding.
scientia non olet · About LEMON Manuals