Piston Pin to Bore Diameter

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Cover the end of the pin bore with a hand or shop rag when removing the retainer ring, since it has a tendency to spring out. Wear eye protection. Failure to follow instructions may result in personal injury.

NOTE: Piston and piston pins are a matched set and should not be interchanged.

Measure the piston pin bore diameter in 2 directions on each side. Verify the diameter is within specification.
- If out of specification, install new components as necessary. Refer to appropriate ENGINE article for the procedure.
  
  Fig 1: Identifying Piston Pin Retainer Ring
  Courtesy of FORD MOTOR CO.
  
  Fig 2: Identifying Directions For Measuring Piston Pin Bore Diameter
  Courtesy of FORD MOTOR CO.