LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Starting System - Starters - Except Diesel) >> On-Vehicle Testing >> Starter Load Test

Starter Load Test

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, 2004 Ford Cutaway, and 2003 Ford RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify battery condition. Battery voltage should be 12 volts or more. Load test battery at approximately one-half cold cranking amperage rating. See load tester manufacturer's instructions. If battery voltage is less than 12 volts or loaded battery voltage is less than 9.6 volts, service battery or charging system as necessary.
  2. Disconnect inertia fuel shutoff switch connector to prevent vehicle from starting during test. Connect ammeter according to tool manufacturer's instructions. Crank engine while observing ammeter. Current draw should be 130-190 amps. If draw is not as specified, replace starter motor. See STARTER MOTOR  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals