Brake Caliper Guide Pins
WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not use power tools for caliper guide pin bore cleaning.
The guide pins should slide with a reasonable amount of hand force. If the brake pads show taper wear or the guide pins are difficult to move, then carry out the following steps.
NOTE:
If a guide pin kit is not available, install a new caliper assembly.
- Disassemble the guide pins. For additional information, refer to DISC & DRUM for front or rear disc brakes.
- Use a wire brush, rolled-up sandpaper or emery cloth to remove all corrosion and foreign material from the caliper guide pin bores. Clean remaining debris from the bores with brake parts cleaner and compressed air.
- Install new brake pads if the lining is not within specifications. For additional information, refer to DISC & DRUM for front or rear disc brakes.
- Assemble the caliper guide pins using new caliper seals, boots and guide pins. Use an ample amount of grease to lubricate the bores and guide pins.